Discussion on placement and recycling of road cones

Before the road maintenance work is carried out, the road cones and traffic signs that guide traffic safety must be placed outside the work area. This is an important task that is related to work safety and driving vehicle safety. After each work is completed, the road cones, etc. are retracted.
1. Take the cone
Before the repair work on the road, the road cones must first be loaded on the truck from the warehouse, and then transported to the construction site. Before working, put the road cones on the road. When road cones are placed, there are two ways to take cones: manual cone extraction and automatic cone extraction.
2. Manual cone extraction
When the road cones are placed, the method of manual cone removal is adopted. The road cones accumulated in the truck compartment are manually removed and put into the road cone placement equipment. The road cones are put into the chute, and the road cones are pushed manually to make the road The cone moves laterally to a straight track, and the road cone slides down on the road along the straight track.
3. Automatic cone extraction
Fully automatic road cone placement equipment uses automatic cone removal equipment when placing road cones. The fully automatic road cone removal system is composed of a horizontal conveying system and a longitudinal conveying storage system. The longitudinal conveying system continuously transports the road cones forward, and its bottom is a belt conveyor. At the end of the belt conveyor, there is a cone puller and a road cone stabilizing fork, which transfers the road cones to the horizontal conveying system; the horizontal conveying system will The road cone is transported outward, and the road cone is moved to the side of the car; then the road cone is taken off by the automatic cone remover and placed on the road, usually horizontally, that is, the road cone is horizontal after being placed on the road situation. There are different types of automatic cone extractors, and there are many forms of cone extraction and cone placement.
4. Upright process of road cone
Traffic cones are in an upright position when in use. The road cone moves from a horizontal track to a straight and zigzag track, and then slides down on the straight track. The road cone changes from a horizontal state to an upright state, that is, the road cone is placed upright on the road after leaving the track. If the automatic cone remover is used, the road cones are usually in a horizontal state when placed on the road surface, and it needs to be changed from a horizontal state to an upright state so that the road cones stand upright on the road surface. Therefore, after the automatic cone remover puts the road cone on the road surface, a special mechanism immediately changes the road cone from a horizontal state to an upright state, making it stand on the ground.
5. Disc type road cone placement and retraction equipment
The disc-type road cone placement and retraction equipment is to pile up the road cones in the compartment. When placing the road cones, the operator puts the road cones into the disc feeder. Hold, the disc rolls to bring the road cone to the road. When the road cone reaches the ground, release the road cone with the expander, and the road cone will fall Put it upright on the road.