Traffic cones are specified by height more often than by any other figure, and the number chosen decides two things at once: how early drivers see the cone and how well it stays put once vehicles pass. A cone that is visible enough for a car park will be missed on a motorway, and a cone sized for a motorway is clumsy inside a building.
The Three Common Heights
Cones are generally produced at around 450 mm, 750 mm and 900 mm. The 450 mm size suits low-speed indoor and car-park work, 750 mm covers most urban and maintenance use, and 900 mm is used on faster roads where the cone has to be read from a distance. Height is measured to the apex of the cone body, so two cones of the same nominal height can differ in visible mass if their base and sleeve design differ.
Visibility
Height sets the viewing distance. A taller cone stands above the spray and the roof lines of parked cars, which matters on wet roads and in traffic. The reflective collar works with the height rather than replacing it: a small cone with a good collar is still a small object at distance.
Stability
A taller cone carries more wind load and is more easily knocked over by a passing vehicle or a gust. The base mass and the base-to-height ratio decide whether the cone recovers after contact. On open roads this is as important as visibility, because a cone that falls has stopped warning anyone.
| Height | Typical Use | Consideration |
|---|---|---|
| 450 mm | Indoor, car parks, low-speed compounds | Compact and easy to store |
| 750 mm | Urban roads, maintenance, events | Balance of visibility and handling |
| 900 mm | Faster roads and longer works | Needs a heavier base for stability |
Base and Weight
Base weight is often what separates a cone that stays upright from one that walks down the road. Rubber bases grip the surface and absorb impact, while lighter PVC bases stack easily but move in wind. For high-speed traffic the base should be chosen for the conditions rather than for the shipping weight.
Specifying for the Site
State the road speed, the exposure to wind and spray and how the cones will be stored and carried. These three points set the height and base that will actually work, and they are more useful on an order than a cone name alone.
